Licence Upgrade

Licence Upgrade

Normally, the NumberOk re-activation process looks as follows:


1. Deactivate the license key.

2. Uninstall NumberOk

3. Install NumberOk with a new license key.


If you would like to preserve settings, please, employ the following workaround:

1. Quit NumberOk if it is up and running

2. Go to C:\ProgramData\FF\NumberOk3\

3. Open NumberOk.ini

4. Try locating the License.Auth and License.Key (somewhere around row 53). These might be absent if NumberOk deactivated itself upon demo license expiration.

5. If License.Auth is present then remove the entire row.

6. If License.Key is present then replace the key sequence (follows the pattern XXXXX-XXXXX-XXXXX-XXXX) with a key provided to you. Otherwise, add a new row starting with License.Key and having the key appended to it. 

6. Save and close NumberOk.ini

7. Launch NumberOk

8. Go to Settings > General

9. Check the Key No. matches the one you’ve been provided with

10. Check that Valid until indicates some date in the future




                                                                           The key replacement procedure is as follows:
​

The key replacement procedure is almost identical to the License Upgrade procedure.

1. Deactivate your current key through the user interface. Tab "Settings" - "Main" - "Deactivate license". Do not delete the database and configuration file. After successful deactivation, Numberok will automatically close.

2. Open the NumberOK.ini configuration file (you can find it in the C:\ProgramData\FF\NumberOk3 folder) with a text editor and replace the key in the License.Key line with a new one.

3. Remove the entire License.Auth line if present.

4. Save the configuration file and close it.

5. Run NumberOK in normal mode and make sure that on the tab "Settings" - "Main" in the field of build information your new license key is displayed.




    • Related Articles

    • Software Update Guidelines

      This short NumberOk update manual is applicable to a single instance installation on a computer that hosts both NumberOk and the database. Should you have multiple instances of NumberOk (including Reporter), please, refer to the Update on Multiple ...

    • Sending events as JSON over HTTP

      Navigate to Settings > Analytic > JSON to setup the integration. Check Enable JSON sender to enable the integration. At Type of recognized text select Unicode plate number. At Protocol version select Version 1.0 Assign unique Sensor ID of your ...

    • Managing NumberOk via DataBase

      Intro Managing NumberOk via FireBird database is considered an unsupported non-documented method. The database is accessible from outside NumberOk and access to the database should be restricted on OS and file system levels. NumberOk vendor doesn’t ...

    • Multiple Workstations Software Update

      Prerequisites Should you have more than one instance of NumberOk (including NumberOk Reporter) sharing the same database make sure to start with a computer that hosts the database file: (a) Open C:\ProgramData\FF\NumberOk3\NumberOk.ini (Check ...

    • Installation

      Preparation for installation To install NumberOk the following is required: SW NumberOk distribution file anpr_setup.exe. Valid stable release is always accessible at the link NumberOk last version Activation code (Licence Key). Installation and ...